Elle Shelley & Jay Rogers, Local Motors - IBM Insight 2015 - #ibminsight - #theCUBE
summary
Claims building the first production 3D printed car with a proof of concept that was printed and driven off the show floor in 2014, now pursuing federal safety and EPA certification for a production debut end of 2016. Uses big-area additive manufacturing with Oak Ridge collaboration, faces material selection and supply‑chain constraints, and runs an open‑source community (hundreds contributing, dozens with original designs). Business model centers on microfactory $10M / 3,000 units, vehicle mix where 80–85% produced by Local Motors, and an EV with a 100 mile EV target. Presales launch via Indiegogo spring 2016.
AI-written summary · about
chapters (15)
- 0:00Start
- 0:2101. Elle Shelley, Local Motors, Visits #theCUBE.
- 0:5002. Jay Rodgers, Local Motors, Visits #theCUBE.
- 1:5704. Customized Manufacturing and Making the Car Road-Worthy.
- 3:4105. Open Sourcing a Car.
- 5:3606. Questions from Potential Consumers.
- 6:2807. Technical and Material Challenges.
- 8:3208. Target Market: The Next Generation.
- 9:2109. Is Local Motors a Direct Competitor with Other Auto Makers.
- 10:3210. Local Motors Makes Approximately 80% of the Vehicle.
- 11:0611. Customization and the Consumer Experience.
- 14:0112. Open Development and Micro Production.
- 15:1913. Cost and Complexity of Printing the Vehicle.
- 18:1414. Shelly's Experience Driving a 3D Printed Vehicle.
- 22:4316. How to Get Your Own 3D Car.
